Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted HVAC Cleaning for Greenwich Village Homeowners
If your apartment smells faintly musty when the AC kicks on, or your energy bill climbed while the air coming out of the registers got weaker, the problem usually isn’t the ducts alone. It’s the mechanical components inside the air handler: a coil matted with dust, a blower wheel caked off-balance, a drain pan growing something you don’t want to think about. HVAC cleaning addresses that equipment directly, and it’s the service most duct cleaners skip because it requires opening the unit and knowing what’s inside. Our technicians have up to 9 years of experience with the fan coils, PTAC units, and central systems common in Greenwich Village’s prewar and postwar buildings. We answer 24/7 and can often schedule same-day visits. Call (855) 337-2008.

What Our HVAC Cleaning Service Includes
HVAC cleaning targets the equipment that moves and conditions air, not just the ductwork that carries it. We break the work into six distinct components, and we’ll tell you which ones your system actually needs after we open it up.
Evaporator Coil Cleaning
The evaporator coil is where refrigerant absorbs heat from your air, and it’s also where every particle that slips past your filter eventually lands. When the fins clog, the coil ices up, airflow drops, and the compressor works harder than it should. We clean coils in place using professional-grade equipment rather than pulling the coil, which keeps the job contained and your downtime short. If you’ve noticed weak cooling or a system that runs constantly without getting the apartment cold, this is usually the first thing we check in a Greenwich Village unit.

Blower Cleaning
The blower wheel pulls air across the coil and pushes it through your ducts. Dust builds on the blades unevenly, throwing the wheel out of balance, and that imbalance shows up as a rumble or a vibration you can feel through the floor. We remove the wheel where the unit allows, clean it properly, and check the motor mounts and bearings while we’re in there. A clean, balanced blower moves the same air at lower speed, which is quieter and easier on the motor.

Condenser Cleaning
The condenser is the outdoor half of a split system, and in Greenwich Village that often means a rooftop unit, a courtyard-mounted condenser, or a unit tucked on a rear fire escape or setback. Coils pack with cottonwood fluff, grit, and the general debris of a dense neighborhood. We clean the coil fins, check that the fan blades are intact and clear of obstructions, and confirm the unit has the airflow clearance it needs to reject heat. A dirty condenser raises head pressure and shortens compressor life.

Air Handler Cleaning
The air handler cabinet houses the blower, the coil, the filter rack, and the drain pan, and it’s the single most neglected piece of equipment in most apartments. We clean the interior surfaces, clear and treat the condensate drain so it doesn’t back up and stain ceilings below, and inspect the cabinet seams and insulation for gaps or deteriorated liner. In older Greenwich Village buildings, we sometimes find failing internal insulation that’s shedding fibers into the airstream, and we’ll flag it before it becomes an air quality problem.
Heat Exchanger Cleaning
If you have a furnace or a packaged unit with a combustion section, the heat exchanger is the part that separates combustion gases from the air you breathe. We inspect and clean it as part of the job, looking for soot buildup, corrosion, and any sign of cracking. A compromised heat exchanger is a carbon monoxide concern, not a performance concern, and it should be evaluated by a trained technician rather than handled as a weekend project. When we find an issue we can’t resolve, we say so plainly and tell you what needs to happen next.
Coil Treatment
Cleaning removes the buildup; treatment slows its return and addresses what cleaning leaves behind. We apply a coil-safe treatment after cleaning to inhibit microbial growth on the fins and in the drain pan, which matters most in humid apartments where the system runs cold and wet for months. This pairs naturally with our air duct cleaning Greenwich Village service when both the equipment and the ducts need attention in the same visit.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for HVAC Cleaning
We work on the equipment that’s actually installed in New York City apartments and townhouses, and that means we see a lot of Honeywell controls and Aprilaire whole-home air quality components. Honeywell thermostats, zone controls, and humidification gear sit on a huge share of the systems we open, and we know how their control boards and sensors interact with the cleaning process, which ones need to be isolated before we start, and where their damper actuators tend to stick. Aprilaire humidifiers and air cleaners are common in buildings that have been updated, and we clean and service around them without disturbing media or bypass assemblies that are working correctly.
On the cleaning side, we run Rotobrush rotary-brush systems and Nikro equipment, and we use Abatement Technologies negative-air and filtration units for containment. That last piece matters in occupied apartments. Negative-air containment keeps dislodged dust and debris from drifting into your living space while we work, and it’s the same protocol used on mold and hazardous-material remediation jobs. Whether you have Honeywell controls, an Aprilaire system, or any other make, we can help.
Signs You Need HVAC Cleaning Right Now
These are the symptoms we hear most often from Greenwich Village residents, and each one points to a specific component worth inspecting.
- Musty or “dirty sock” smell when the system starts. That odor usually comes from microbial growth on the evaporator coil or in the drain pan, not from the ducts. Cleaning and treating the coil addresses the source; masking it with a filter or a plug-in doesn’t.
- Weak airflow from the registers. A clogged coil or a dust-loaded blower wheel restricts air at the source. If some rooms feel fine and others don’t, the restriction is often in the air handler rather than the branch ducts.
- Rising energy bills without a rate change. A dirty condenser and a fouled coil both force the system to run longer for the same result. The cost shows up on your bill before it shows up as a breakdown.
- Visible dust settling quickly after cleaning. If surfaces re-dust within a day or two, the system is redistributing what it’s holding. That’s a sign the blower, cabinet, and ducts all need attention together.
- Rattling, rumbling, or vibration at startup. An out-of-balance blower wheel is the usual culprit. Left alone, the imbalance wears the motor bearings and can eventually seize the wheel.
Our HVAC Cleaning Process – Step by Step
We don’t improvise. Every job follows the same sequence, and you’ll know what’s happening at each stage before we start.

- 1
Inspection and documentation. We open the air handler, photograph the coil, blower, drain pan, and cabinet interior, and measure airflow and static pressure where the setup allows. You see the condition before cleaning, not after.
- 2
Containment setup. We position Abatement Technologies negative-air and filtration units to hold dust inside the work zone. Supply and return registers get sealed or covered so debris can’t migrate into occupied rooms.
- 3
Mechanical cleaning. Coils are cleaned with coil-safe solutions and proper rinsing. Blower wheels are removed and cleaned where accessible, or cleaned in place with the right tooling when they aren’t. The cabinet interior, drain pan, and drain line get cleaned and flushed.
- 4
Treatment and reassembly. We apply coil treatment to inhibit regrowth, replace or re-seat components exactly as they came out, and verify the drain runs clear. Every part goes back where it belongs.
- 5
Verification and before-and-after photos. We restart the system, confirm airflow and temperature split, and walk you through the photos we took at the start. You get documentation of what changed, which is the difference between a cleaning you can verify and one you have to take on faith.
See the difference
Before
After
Before
After
Before
AfterHow Much Does HVAC Cleaning Cost in Greenwich Village?
HVAC cleaning in Greenwich Village typically runs $250 to $650 for a single air handler with coil and blower cleaning, and $400 to $900 for a full system that includes the condenser and coil treatment. Exact pricing depends on the number of units, how accessible the equipment is, and how much buildup we find once the cabinet is open. In this neighborhood, a lot of apartments have fan coil units in closets or above ceilings with limited working room, and that access reality affects labor more than the cleaning itself.
Here’s what shapes the number:
- System count and type. One central air handler is a different job from two or three fan coils serving a duplex.
- Access. A unit behind a louvered closet door is straightforward. One above a ceiling with a small access panel takes longer.
- Condition. Heavy biological growth or a drain pan that needs treatment adds steps.
- Scope. Adding ductwork, sealing, or sanitizing in the same visit usually costs less than booking it separately.
You avoid overpaying by getting one flat price per system agreed before work starts, with the scope written down and photos to verify it. Our estimates are free, and the written estimate sets the final price. Call (855) 337-2008 for an exact quote on your system.
HVAC Cleaning Near Greenwich Village – Our Service Area
We connect homeowners and property managers throughout Greenwich Village with local professionals who handle HVAC cleaning across the surrounding neighborhoods. If you’re just east of us in the East Village, or managing a building near Union Square, we can usually arrange a visit quickly; same-day scheduling is often possible. We also cover Chelsea, Gramercy, and the Lower East Side, and downtown through the Financial District and Battery Park City.
Serving Greenwich Village, NY – Our Local Coverage Area
We serve Greenwich Village and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – HVAC Cleaning in Greenwich Village
HVAC cleaning is the cleaning of the mechanical components that condition and move air: the evaporator coil, blower, condenser, air handler cabinet, and where applicable the heat exchanger. It’s different from duct cleaning, which addresses the distribution system rather than the equipment. Most homes benefit from both, often in the same visit, and we’ll tell you honestly which one your system needs.
A single air handler with coil and blower cleaning typically takes 2 to 3 hours. A full system that includes the condenser and coil treatment usually runs 3 to 5 hours. Multiple units in one apartment add time per unit. We’ll give you a realistic window with the estimate, not an optimistic one.
Typical estimates fall between $250 and $650 for a single air handler and $400 to $900 for a full system with condenser work and coil treatment. Variables include access, unit count, and condition. The written estimate sets the final price. Call (855) 337-2008 for an exact quote – estimates are free.
Yes, we service Honeywell controls and Aprilaire whole-home air quality equipment as part of HVAC cleaning, and we’re careful to isolate controls and protect media during the work. We’re not a dealer, so we won’t push replacement hardware you don’t need.
Same-day visits are often available, depending on the day’s schedule. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening.
We stand behind the work we perform, and our satisfaction guarantee means we’ll address anything that falls short of what we described. Because no specific written warranty policy has been confirmed, we won’t quote terms here; ask when you call and we’ll be straight with you about what’s covered.
Clear access to the air handler and any closet doors around it, and secure pets in a room away from the work area. We handle the rest, including containment and cleanup. If your unit sits behind stored items, moving them beforehand shortens the visit.
Schedule Your HVAC Cleaning Service in Greenwich Village Today
If your system is running harder than it should, or you’ve never had the coil and blower opened, a cleaning is the most direct way to find out what condition your equipment is really in. Call (855) 337-2008 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Air Duct Cleaning Greenwich Village.